Item Parameter Explanation
Periodical Cleaning Off Choose the frequency with which the printer performs head cleaning:
never (Off) or after 1 to 24 hours. Periodical Cleaning will not be
performed while Off is selected.1If a value between 1 and 24 hours is
selected, auto head cleaning will be performed after the specified number
of hours. If printing is in progress or the printer is in sleep mode when the
specified time has elapsed, Periodical Cleaning will only be performed
after printing is complete or the printer is reactivated.
The following reset the timer:
❏ Turning the printer on.
❏ Choosing another option for this item.
❏ Manually performing head cleaning using All Nozzles.
Note that even when Off is selected for Periodical Cleaning, the printer will
automatically clean the print head at a fixed interval after printing to keep
the nozzle from clogging.
1 to 24 hours
Cleaning Cycle
Off Choose the frequency with which the performs auto head cleaning: never
(Off) or once every 1 to 10 pages. Head cleaning will not be performed
while Off is selected.1Select 1 to 10 to perform head cleaning before the
specified number of pages is printed.
1 to 10 pages
Heat Off Timer 15 to 240 minutes You can turn off the heaters automatically when no errors are detected
and no print jobs are in progress. This option is used to choose the interval
before the heaters turn off automatically.
The printer will enter sleep mode when the Heat Off Timer expires. In sleep
mode, the control panel turns off and the internal motors and other
components consume less power. If an additional print drying system
(supplied with the SC-S50600 series; optional with other models) is
installed, it will turn off automatically.
To reactivate the control panel display, press any button in the control
panel except P. The control panel display will however turn off again if no
operations are performed for another 30 seconds under these conditions.
The printer and heaters are only fully reactivated when a print job is
received, the media loading lever is used, or another operation involving
printer hardware is performed.
Head Mode
1
2 Heads Mode Select this option for dual-head printers to continue printing with the
remaining head when one of the heads is clogged.
The head that will be used can be determined by printing a nozzle check
pattern as part of a nozzle clog test.
U “Checking for clogged nozzles” on page 75
U “Head Mode Adjustment” on page 76
Head 1
Head 2
Restore Settings Yes
Select Yes to restore all items in the Printer Setup menu to their default
settings.
No
The Maintenance Menu
The Maintenance menu can be accessed directly by pressing the # button.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Using the Control Panel Menu
106
To Next Page
Loading...
