c
Important:
Note that the auto take-up reel unit may not
function as expected when ink layering is
performed with the SC-S70600 series or SC-S50600
series, causing a decline in print quality.
Ink layering U “High Print Quality” on page 23
Attaching the Roll Core
A
After confirming that the media is loaded
correctly, press the d button to feed the media as
far as the auto take-up reel unit roll core holder.
B
Loosen the roll core holder fixing screws and
adjust the roll core holders so that the gap
between the two is wider than the media.
Center the roll supports between the roll holders.
C
Align the right roll core holder with the right
edge of the media and tighten the fixing screw.
D
Insert the roll core onto the right holder.
E
Insert the left holder into the roll core.
Slide the holder in until part A in the illustration
below is fully inserted.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
56
To Next Page
Loading...
