Printable Side In
If the label does not have the loading position,
mark it on the label as instructed in the Setup
Guide.
U Setup Guide
Note:
Be sure the option selected for Roll Type in the
Customize Settings menu matches how the media
is rolled. Roll Type defaults to Printable Side Out.
Be sure to select Printable Side In after loading
media rolled printable side in.
For more information see U “Roll Type” on
page 65
D
Raise the lift lever on the left side of the printer to
lift the media into position, then firmly insert the
roll holder.
If the roll of media has the outer diameter which
is less than 140mm, lift it up by your hands, and
set it to the roll holder. The roll core will not reach
the holder when raised using the lift lever.
E
Tighten the roll holder screw to fix the roll holder
in place.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
44
To Next Page
Loading...
