Note:
Media that is heavy and difficult to unroll can be
fed by pressing the drive switch on the left roll
holder.
Printable Side Out
Printable Side In
K
Insert the media past the pressure rollers and
lower the media loading lever to hold it in place.
Confirm that the left edge of the media passes
over the center of the square in the label on the
pre-heater.
c
Important:
Perform Steps 11 to 3 in reverse order and
repeat the loading process if the left edge of the
media is not within the guides. Do not
attempt to reposition the roll holders while
they are inserted in the media.
L
Go to the front of the printer and open the front
cover.
M
Hold the center of the media and raise the media
loading lever.
N
Pull the media straight forward until the edge has
past the label on the left side of the after heater.
Keep the right edge of the media parallel with the
scale markings on the two labels on the right side
of the after heater.
O
Lower the media loading lever to hold the media
in place.
To print immediately, proceed to Step 16.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
46
To Next Page
Loading...
