Note:
Pressure rollers not within the bounds indicated by the black labels do not apply pressure to the media when the media
loading lever is lowered. Pressure rollers that are within a black label but not over the media will cause friction during
printing; be sure to position rollers that are not over the media outside the black labels.
Using the High Pressure Rollers
Position the high pressure rollers within 10 mm of the edges of the media inside any of the black labels from A to J in
the “Positioning Media of Different Widths” illustration. The gray area in the illustration below shows the printable
area. The arrow indicates the feed direction.
A: Pressure rollers (high)
1 The value selected for Side Margin(Left) in the setup menu. The default value is 5 mm.
2 The total of the values selected for Print Start Position and Side Margin(Right) in the setup menu. The default value is 5 mm.
Note:
The margins may not conform to the values selected in the document (or application). If the value selected for Side Margin or
Print Start Position is changed, documents that fill the printable area will not be printed to the full width of the media.
Using the Low Pressure Rollers
Position the low pressure rollers within 5 mm of the edges of the media inside any of the black labels from A to J in the
“Positioning Media of Different Widths” illustration. The gray area in the illustration below shows the printable area.
The arrow indicates the feed direction.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Basic Operations
71
To Next Page
Loading...
