Menu Item Parameter
Media Setup
U “The Media
Setup Menu” on
page 100
Media Remaining
Remaining Setup On, Off
Length 5.0 to 99.5 m (15 to 300 ft)
Remaining Alert 1 to 15 m (4 to 50 ft)
Print Remaining Length Print
Select Media RIP Settings, 1 to 30 (media setting bank number)
Customize Settings
Current Settings Change settings for currently selected media. The options
available depend on whether RIP Settings or a media setting
bank is selected. More information on the options available
can be found below in the entries for RIP Settings and media
setting banks 1 to 30.
RIP Settings
Platen Gap 1.5, 2.0, 2.5
Head Alignment
Input thickness.
Auto(Uni-D), Auto(Bi-D), Auto(Dual Head)
1
, Manual(Uni-D),
Manual(Bi-D), Manual(Dual Head)
1
Roll Type Printable Side Out, Printable Side In
Tension Measurement Periodically, Every Page, Off
Media Tension 0 to 40
1 to 30 (media setting bank number)
Setting Name Up to 22 half-size characters
Feed Adjustment Auto, Manual
Platen Gap 1.5, 2.0, 2.5
Head Alignment
Auto(Uni-D), Auto(Bi-D), Auto(Dual Head)
1
, Manual(Uni-D),
Manual(Bi-D), Manual(Dual Head)
1
Heating & Drying
Heater Temperature Pre-heater/platen heater: 30 ˚C to 50 ˚C (86 ˚F to 122 ˚F)
After heater: 30 ˚C to 55 ˚C (86 ˚F to 131 ˚F)
Drying Time Per Pass 0 to 10sec
After Heater Feed Mode 1, Mode 2, Off
Additional Dryer On, Off
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Using the Control Panel Menu
96
To Next Page
Loading...
