1-8 General Information Rev. A
• Use thinner paper (N30 or equivalent) between the top and bottom sheets of multi-ply
paper. If thick paper is used, the copy capability is lowered.
Prohibited area for paper holes and low reflection
15
30
20
10
Paper feed direction
Paper holes and
translucence prohibited in
this area.
Area where paper holes are
prohibited and reflection rate
for the surface on paper
should be 40% or more.
Area where paper holes are
prohibited and reflection rate
for the back on paper should
be 40% or more.
[Units: mm (All the numeric values are typical.)]
To Next Page
Loading...
