Epson TM-T88VII - Paper Specifications

113
Appendix
Paper Specifications
Paper types Specified thermal paper
Form Roll paper
Size Roll paper diameter 83 mm {3.27"} maximum
Roll paper spool Inside: 12 mm {0.47"}, Outside: 18 mm {0.71"}
Roll width when taken up 80 mm width paper printing: 80 + 0.5/-1.0 mm
58 mm width paper printing: 58 + 0.5/-1.0 mm
Paper width 80 mm width paper printing: 79.5 ± 0.5 mm
58 mm width paper printing: 57.5 ± 0.5 mm
Paper thickness Maximum of 80 μm, minimum of 48 μm
Specified original paper type AP45KS-ND, AP50KS-ND (Jujo Thermal Oy)
P5047(46), P5047(55) (Mitsubishi HiTec Paper Europe GmbH)
KT55FA, KT48FA, KT55PF, KT48PF (Papierfabrik August Koehler SE)
Epson Certified Media List for Thermal Receipt Printers
U w
ww.epson-biz.com/?content=sht_tm_media
• Paper must not be pasted to the roll paper spool.
• The remaining amount of the roll paper when a roll paper near-end is detected differs
depending on the spool type.
• Use of thermal paper with a pre-printed recording surface should be avoided. Using it can
cause the thermal head to stick to the thermal paper surface during printing, and cause
printing failure and other problems. The pre-printing also can result in reduced print density.
Using thermal paper with a pre-printed recording surface, pre-printing should be done in
accordance with the conditions (ink type, printing and other conditions) recommended by the
paper manufacturer, and the thermal paper should be checked to ensure that there is no
faulty printing, loss of print density, or other problems.