58
Chapter 3 Advanced Usage
Selecting the BUSY Status
With DIP switch 2-1, you can select conditions for invoking a BUSY state as either of the following:
• When the receive buffer is full
• When the receive buffer is full or the printer is offline
Printer BUSY Condition and Status of DIP Switch 2-1
In either case above, the printer enters the BUSY state after power is turned on (including resetting
with the interface) and when a self-test is being run.
Printer status
DIP SW 2-1
ON OFF
Offline During the period after power is turned on (including resetting
with the interface) to when the printer is ready to receive data.
BUSY BUSY
During the self-test. BUSY BUSY
When the cover is open. — BUSY
During paper feed with the Feed button. — BUSY
When the printer stops printing due to a paper-end (when
printer has run out of roll paper).
—BUSY
When a macro is executed and waiting for the power is turned
on.
—BUSY
When an error has occurred. — BUSY
When the receive buffer becomes full. BUSY BUSY
To Next Page
Loading...
