83
Chapter 3 Advanced Usage
Resetting the Interface Settings
Follow the steps below to restore the interface settings to the factory default.
1
Turn off the printer and close the roll paper cover.
2
If the connector cover is attached, remove the cover.
See "Attaching the Connector Cover" on page 44 for details on removing the connector cover.
3
Hold down the status sheet button while turning on the printer.
A message is printed indicating that resetting is being performed, and the printer restarts.
• You can return the interface settings to their defaults from the Interface Setup mode. See
"Interface Setup Mode" on page 76 for details on the Interface Setup mode.
• Only
network settings are returned to their defaults.
Hold down the status sheet button until the initialization execution message is printed.
To Next Page
Loading...
