53
Chapter 3 Advanced Usage
Serial Model
DIP Switch Bank 1
Transmission Speed (DIP Switches 1-7/1-8)
bps: bits per second
* The default value of transmission speed set with software settings is 38400 bps. (See "Software Settings" on
pa
ge 59.)
SW Function ON OFF
Default
setting
1-1 Data reception error Ignored Prints “?” OFF
1-2 Reserved (Do not change the setting) Fixed to OFF OFF
1-3 Handshaking XON/XOFF DTR/DSR OFF
1-4 Word length 7 bits 8 bits OFF
1-5 Parity check Yes No OFF
1-6 Parity selection Even Odd OFF
1-7
Baud rate selections
See the " Transmission Speed (DIP
Switches 1-7/1-8)"
table below.
ON
1-8 OFF
Transmission speed (bps: bits per second) SW 1-7 SW 1-8
Depends on the software setting mode settings.* ON ON
4800 OFF ON
9600 (default) ON OFF
19200 OFF OFF
Depending on print conditions, such as print duty, print head temperature, and data transmission
speed, print speed is automatically adjusted, which can cause white lines due to intermittent
print (the motor sometimes stops). To avoid this, set the transmission speed higher or keep the
print speed constant by setting it lower.
To Next Page
Loading...
