134
Appendix
Writing the configuration script to the printer
You can save a configuration script to the printer using the HTTP POST method.
You can save the configuration script to volatile or non-volatile memory.
When changing using a low frequency less than once an hour, you can save to non-volatile memory; however,
when changing at a higher frequency, you need to save to volatile memory.
When the change is successful, the advertising data is changed.
Request
See the POST parameters in Table 10 Response for the parameters.
Response
Table 9 Response Header
200 OK
The HCI Version for the Bluetooth
adapter is 5 or lower
{
"message": "Success",
"detail": null,
"description" : {
“VendorID”: “0a12”,
“ProductID”: “0001”,
“ProductName”: “(no name)”,
“Bluetooth LE”: “Not support”
}
}
404 Not Found
Adapter not connected
"message": "Beacon dongle not connected",
"detail": null,
"description" : null
}
Content-Type: text/json; charset=utf-8
http://(printer IP address)/webconfig/beacon.cgi
Content-Type: application/json; charset=utf-8
Access-Control-Allow-Origin: *
Access-Control-Allow-Methods: POST, GET, OPTIONS, HEADER
Access-Control-Allow-Headers: Content-Type, Content-Length, Authorization
X-Content-Type-Options: nosniff
X-XSS-protection: 1; mode=block
X-Frame-Options: deny
Content-Security-Policy: default-src 'none'
X-RateLimit-Limit: 1 (when type=static only)
X-RateLimit-Remaining: 1 or 0 (when type=static only)
X-RateLimit-Reset: 1390941626 (when type=static only)
WWW-Authenticate: Digest realm="<IPaddr>", nonce="xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx", qop="auth"
Response Status Response Body
To Next Page
Loading...
