Rev. E Notices for Replacement of the TM-U210/TM-U300 6-13
TM-U220 Technical Reference Guide
6.2.6 Provided statuses and detectors
TM-U220 has same statuses as TM-U210/TM-U300. In addition, the TM-U220 has new statuses.
The following sections describe them.
6.2.6.1 Newly added Status
The following statuses have been added for the TM-U220. About the use of these statuses , see
“5.1 Various Status Categories (5-1 page).”
❏ Roll paper cover open/close status
❏ Roll paper near-end status (When equipped with a near-end detector [Factory option])
6.2.7 Use for Journal
TM-U220 Type A is able to be used for journal as TM-U300 (Type A, C.) However, notice the
following item when you replace the TM-300 with the TM-U220.
❏ The TM-U300 can print on carbon roll paper with 2 copies; however, the TM-U220 can print
carbon roll paper with 1 copies, not 2 copies.
6.2.8 Added new functions
6.2.8.1 Wall hanging
The TM-U220 can be installed on a wall. The installation requires an option, the “WH-10.“
6.2.8.2 NV bit-image
The TM-U220 can print bit-image on roll paper. See “5.4 NV Bit-image Printing (5-8 page)” for
detail.
6.2.8.3 User NV memory
The TM-U220 can store some text data. See “5.3 NV memory (5-6 page)” for detail.
6.2.8.4 Memory Switch and Memory Switch setting mode
The TM-U220 has a memory switch ,which is a software DIP switch. The memory switch setting
mode is for adjusingt the memory switches by printer only (No need for a host PC.) See “3.4.3
Memory Switches (3-17 page)” and “3.4.4 Memory Switch Setup Mode (3-19 page)” for details.
6.2.9 Driver compatibility
This section informs you the compatibility and notices for replacing.
To Next Page
Loading...
Need help?
General
