Rev. E Setup 3-33
TM-U220 Technical Reference Guide
2. Set up the device and environment.
1. Set the device setting by using SetupPOS utility.
• Select the device and I/F setting.
• Device specified setting. (set the specified setting of the device)
2. Execute the CheckHealth
Device communication test.
• If you get "SUCCESS", the setting of the device is right.
• If you get ResultCode (error), please re-check the device connection setting by
following the User's Manual.
After performing the above procedure, please use an OPOS compliant program in your system.
Note:
Please refer to the sample program when you make a program.
OPOS ADK provides a sample program for each device class. The sample programs are intended as
programs to serve as references for application developers. The ways to use the principal methods and
properties for each device are introduced in the form of Visual Basic, Visual C++ programs. In this
manual, it is introduced in the form of Visual Basic.
3.5.1.2 Package contents of EPSON OPOS ADK.
Package contents of EPSON OPOS ADK are same as that of the previous one.
❏ Installer
❏ SetupPOS Utility
❏ OPOS Controls
❏ Manual
• User’s Manual :Installation of the EPSON OPOS ADK, Configurations,and explanations
of the attached tools.
• ADG : Detailed information on the each device to support the development.
❏ Sample Program
Sample program for VB and VC (for each device class)
ADG for General : General information on the development.
ADG for Common Information : Common information to all the devices.
ADG for device class : General information on the device class.
ADG for model : Specific explanation on the device.
Sample program : Information on the Sample Programs.
To Next Page
Loading...
Need help?
General
