299
Cleaning and Transporting Your Product
See these sections if you need to clean or transport your product.
Cleaning Your Product
Cleaning the Scanner Glass
Cleaning the Automatic Document Feeder
Transporting Your Product
Cleaning Your Product
To keep your product working at its best, you should clean it several times a year.
Caution: Do not use a hard brush, benzene, alcohol, or paint thinner to clean the product or you may
damage it. Do not use oil or other lubricants inside the product or let water get inside it. Close the rear
paper feed slot when you are not using it, to keep out dust.
1. Turn off the product.
2. Clean the outer case and control panel with a soft, clean cloth that has been dampened with water.
For stubborn dirt, add a small amount of mild detergent to the damp cloth.
Note: Do not touch the parts shown in the following image. This may cause a malfunction.
To Next Page
Loading...
Need help?
General