Epson WorkForce Pro WF-3730 Series - Fax Header and Document Handling; Sending Fax with Selected Header

5. Tap the Ti me box, enter the time you want to send the fax, and then press OK.
6. Tap OK to apply the settings.
Note:
You cannot send another fax until the fax has been sent at the specied time. If you want to send another one, you need
to cancel the scheduled fax by tapping Fax on the home screen, and then deleting it.
Related Information
& “Placing Originals” on page 48
& “Sending Fax Using the Control Panel” on page 116
& “Fax Settings” on page 129
Sending a Fax with a Selected Header
You can send a fax with sender information that is suitable for the recipient. You need to register multiple headers
of sender information in advance in the printer by following the steps below.
Registering Multiple Headers for Sending Faxes
You can register up to 21 fax headers as sender information.
1. Tap Settings on the home screen.
2. Tap General Settings > Fax Settings > Basic Settings.
3. Tap Header, tap the Your Phone Number box, enter your phone number, and then tap OK.
4. Tap one of the boxes under the Fax Header list, enter the fax header information, and then tap OK.
Related Information
& “Fax Settings” on page 129
Sending a Fax with a Selected Header
When you send a fax, you can select header information for the recipient. To use this feature, you must register
multiple headers in advance.
1. Tap Fax on the home screen.
2. Tap Fax Settings > Add Sender Information.
3. Select where you want to add your sender information.
❏
O
: Sends a fax with no header information.
❏ Outside of Image: Sends a fax with header information in the top white margin of the fax. is keeps the
header from overlapping with the scanned image, however, the fax received by the recipient may be printed
across two sheets depending on the size of the originals.
User's Guide
Faxing
119