Epson WorkForce Pro WF-3730 Series - Sending Different Size Documents via ADF

❏ Inside of Image: Sends a fax with header information approximately 7 mm lower than the top of the
scanned image. e header may overlap with the image, however, the fax received by the recipient will not
be split into two documents.
4. Tap the Fax Header box, and then select the header you want to use.
5. Tap one of the Additional Information options as necessary.
6. Tap OK to apply the settings.
Related Information
&
“Fax Settings” on page 129
Sending Dierent Size Documents Using ADF (ADF Continuous Scan)
If you place
dierent
sized originals in the ADF, all of the originals are sent at the largest size among them. You can
send them in their original sizes by sorting and placing them by size, or placing them one by one.
Before placing originals, make the following setting.
Tap Fax on the home screen, tap the Fax Settings tab, and then tap the ADF Continuous Scan box to set this to
On. Follow the on-screen instructions to place originals.
e
printer stores the scanned documents, and sends as one document.
Note:
If you leave the printer untouched for 20 seconds aer prompted to set the next originals, the printer stops storing and starts
sending the document.
Related Information
& “Fax Settings” on page 129
Sending a Fax from a Computer
You can send faxes from the computer by using the FAX Utility and PC-FAX driver. See the help of FAX Utility and
PC-FAX driver for the operating instructions.
Related Information
& “PC-FAX Driver (Fax Driver)” on page 166
& “FAX Utility” on page 166
Receiving Faxes
Setting Receive Mode
You can ma ke a Receive Mode using Fax Setting Wizard. When making fax setting at the rst time, we
recommend you to use the Fax Setting Wizard. If you want to change only the Receive Mode, follow the
instruction below.
User's Guide
Faxing
120