Epson WorkForce Pro WF-3730 Series - Changing Network to Ethernet Connection; Disabling Wi-Fi Connection

Select Set up Printer connection again (for new network router or changing USB to network, etc.) on the Install
Soware
screen, and then click Next.
Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Settings on the home screen.
2. Select General Settings > Network Settings > Wi r e d L A N S etu p.
3.
Tap Start Setup.
4. Check the message, and then close the screen.
e screen automatically closes aer a specic length of time.
5.
Connect the printer to a router using an Ethernet cable.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
User's Guide
Network Settings
38