Related Information
& “Network Settings” on page 278
E-11
Solutions:
Check the following.
❏ e default gateway address is correct if you set the printer’s TCP/IP Setup setting to Manual.
❏ e device that is set as the default gateway is turned on.
Set the correct default gateway address. You can check the default gateway address from the Network Status part
on the network connection report.
Related Information
& “Network Settings” on page 278
E-12
Solutions:
Check the following.
❏ Other devices on the network are turned on.
❏ e network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them
manually.
❏ e network addresses for other devices (subnet mask and default gateway) are the same.
❏ e IP address does not conict with other devices.
If still does not connect your printer and network devices aer conrming the above, try the following.
❏ Tur n
o
the wireless router. Wait for about 10 seconds, and then turn it on.
❏ Make network settings again using the installer. You can run it from the following website.
http://epson.sn > Setup
❏ You can register several passwords on a wireless router that uses WEP security type. If several passwords are
registered, check if the
rst
registered password is set on the printer.
Related Information
& “Network Settings” on page 278
& “Making Settings for Connecting to the Computer” on page 234
E-13
Solutions:
Check the following.
Adding or Replacing the Computer or Devices
>
Checking the Network Connection Status
>
Printi
…
255
To Next Page
Loading...
Need help?
General
