Related Information
& “Setting a Shared Network Folder” on page 456
& “Conguring a Mail Server” on page 452
Using Document Capture Pro Server
By using Document Capture Pro Server, you can manage the sorting method, saving format, and forwarding
destination of a scanning result executed from the printer's control panel. You can call and execute a job previously
registered on the server from the printer's control panel.
Install it on the server computer.
For more information on Document Capture Pro Server, contact your local Epson
oce.
Setting Server Mode
To use Document Capture Pro Server, set up as follows.
1.
Access Web Cong and select the Scan/Copy tab > Document Capture Pro.
2.
Select Server Mode for Mode.
3.
Enter the address of the server with Document Capture Pro Server installed on it for Server Address.
Enter between 2 and 255 characters in either IPv4, IPv6, host name or FQDN format. For FQDN format, you
can use alphanumeric characters in ASCII (0x20-0x7E) and "- " except for at the beginning and end of the
address.
4.
Click OK.
e network is re-connected, and then the settings are enabled.
Scanning From a Computer
Install the
soware
and check that the network scan service is enabled to scan via a network from the computer.
Software to be installed
❏ Epson Scan 2
is is a scanner driver. If you use the device from a computer, install the driver on each client computer. If
Document Capture Pro/Document Capture is installed, you can perform the operations assigned to the buttons
of the device.
If EpsonNet SetupManager is used, the printer driver is also distributed as a package.
❏ Document Capture Pro (Windows)/Document Capture (Mac OS)
It is installed on the client computer. e jobs registered on a network computer where Document Capture Pro/
Document Capture is installed can be called and run from the device's control panel.
You can scan over the network from a computer. Epson Scan 2 is required to scan.
Administrator Information
>
Settings to Use the Printer
>
Preparing to Scan
485
To Next Page
Loading...
