Epson WorkForce Pro WF-C879RBAM - Menu Options for Network Settings (When Using an Additional Network)

Cannot Use the LDAP Server
The network with the LDAP server is not selected correctly.
e LDAP server on either the standard or additional network is available. Make sure that the network that has the
LDAP server you want to use is selected correctly.
Related Information
& “Selecting a Network that has an LDAP Server (When Using an Additional Network)” on page 353
Menu Options for Network Settings (When Using an Additional
Network)
is section explains the Network Settings menu when using the additional network.
Select the menus on the control panel as described below.
Settings > General Settings > Network Settings
Standard:
Set up the standard network. See Related Information below.
Related Information
& “Network Settings” on page 384
Additional:
Set up the additional network.
Network Status:
Displays or prints the current network settings.
❏ Wired LAN Status
❏ Print Status Sheet
Advanced:
Make the following detailed settings.
❏ TCP/IP
❏ IPv6 Address
❏ Link Speed & Duplex
❏ Redirect HTTP to HTTPS
❏ Disable IPsec/IP Filtering
❏ Disable IEEE802.1X
You need to enter the administrator password for the additional network.
Using Optional Items > Ethernet Board (10/100/1000 Base-T, Ethernet) > Menu Options for Network Settings ( …
355