Charging the Battery with a USB Connection
You can charge the battery from a battery charger or a computer with a USB connection.
e following shows the printer's charging specications.
❏ Input for charging with a USB connection: DC 5 V (maximum 1.5 A)
❏ Charging time:
USB Port (5 V/1.5A): Approx. 2.5 hours
USB Port (5 V/0.5 A): Approx. 10 hours
❏ Battery capacity of current: 1860 mAh (3.6 V)
Follow the instructions below to charge the battery from a computer.
1. Make sure that the computer is on. If the computer is in hibernate or sleep mode, you cannot charge the
battery; if this happens, wake the computer.
2. Connect the printer to the computer using a micro USB cable.
Note:
You cannot charge the battery using a USB hub. Connect the printer directly to the computer.
3. If the printer is on, press the
P
button to turn it o.
Note:
❏ If battery charging does not start, select Menu > Battery > Battery Settings on the control panel, enable USB Power
Supply via PC, and then try again.
❏ You can charge the battery when the printer is in sleep mode even if you do not turn o the printer.
❏ During charging, the computer recognizes the printer as a USB mass storage device.
❏ e battery charging light turns on when the battery is charging, and turns o when charging is complete.
User's Guide
Charging the Battery
52
To Next Page
Loading...
