3736
5 Roadside Inspection
This chapter describes the functions that you perform during a
roadside inspection. Change the EROAD ELD to the Roadside
mode when a roadside inspection occurs. This must be done
before handing the device to the inspector. The inspector
can see only the required information when the device is in
Roadside mode. The EROAD ELD does not allow the inspector
to change your logs. It allows the inspector to either transfer or
display your records.
Note: The inspector might ask you to power o the ignition, but
power is still supplied to the EROAD ELD.
Perform the following steps to change to Roadside mode.
1. Change your duty status to On duty. See section 2.3,
Changing Your Duty Status for more information, if needed.
2. Tap the Logs icon on the Home menu. The Logs screen
appears.
3. Tap the Roadside icon on the Logs menu. The
Roadside Inspection screen appears, as shown in section
5.1, Transferring Your Records.
4. Remove the EROAD ELD by loosening the fastener on the
mounting arm.
5. Hand the device to the inspector along with the visor cards
and follow instructions. The inspector might request that
you either transfer (export) your records or display the
records. These functions are described in the following
sections.
4. Enter your email address in the Email Logs field.
Note: Press and hold the Backspace key to erase the
entire field, if needed.
5. Tap the Send button to complete this action. A
confirmation message displays the email address where the
logs were sent.
To Next Page
Loading...