41
F3 Operating the Appliance for the First Time
Remove the battery cover on the rear of the remote. Insert the new “AA” size batteries, paying atten-
tion to the polarity.
You should now see on the display of the remote the time showing “0:00”.
To turn the fire on, press the “POWER” button once, and within a few seconds the appliance will begin
its startup sequence.
NOTE: once the rear burner has lit there will be a fixed 15 second delay before the front burner will
light.
When the appliance has lit, set the room temperature by pressing the ‘plus’ or ‘minus’ button re-
peatedly until the display is showing the desired temperature. The remote will then revert back to the
‘current’ room temperature 30 seconds after making the change.
Run the appliance on full for an hour with the windows and doors open in the dwelling. This will ensure
any running-in smells have the chance to dissipate.
The appliance is turned o by pressing the “POWER” button once more. The remote will display the
time only.
Run the appliance again and check the operation of the thermostat by increasing and reducing the set
temperature. Check the Flame Eect function and the Fan Boost functions work correctly.
For further operation instructions please refer to the User Guide.
To Next Page
Loading...
