P4/62 T-IM114b
CONTENTS
1.0 PRELIMINARY INFORMATION ..............6
1.1 General 6
1.2 About this manual.......................................... 6
1.3 Table description ........................................... 7
2.0 TABLE PARTS AND SYMBOLS ............. 8
2.1 Part identification ........................................... 8
2.2 Symbols and graphics ................................... 8
2.2.1 Symbols general ...................................... 8
2.2.2 Handset button symbols ........................... 9
2.2.3 Handset graphics ..................................... 9
2.2.4 Standby control panel button symbols ...... 9
3.0 INSTALLATION ...................................13
3.1 General ..................................................... 13
3.2 Lifting the operation table ............................ 14
3.3 Technical ..................................................... 14
4.0 SAFETY NOTES & CAUTIONS ............15
4.1 Warnings ..................................................... 15
4.2 Do’s and Don’ts ........................................... 16
4.3 Daily ‘Before use’ test.................................. 16
4.4 Accessories................................................. 16
4.5 Manual handling .......................................... 17
5.0 OPERATING THE TABLE ...................18
5.1 Operating the table base ............................. 18
5.1.1 T20-a and T20-s base ............................ 18
5.1.1.1 ‘Wheel’ orientation (from ‘braked’) 18
5.1.1.2 ‘Castor’ orientation (from ‘wheel’) . 18
5.1.1.3 ‘Castor’ orientation (from ‘braked’) 19
5.1.1.4 ‘Braked’ orientation ...................... 19
5.1.2 T20-m table base .................................. 20
5.1.2.1 Foot pedal operation .................... 20
5.1.2.2 ‘Braked’ ........................................ 20
5.1.2.3 ‘Castor’ mode ............................... 20
5.1.2.4 ‘Wheel’ mode ............................... 22
5.1.3 Moving table with a patient ..................... 22
5.2 Using the removable sections. .................... 23
5.2.1 Re-aligning a section’s pins .................... 23
5.2.2 Attaching a removable section ............... 23
5.2.3 Removing a tabletop section .................. 24
5.2.4 Removable section adjustment .............. 24
5.2.5 Changing sections during a procedure ... 25
5.2.6 Attaching/Removing mattresses ............. 25
5.3 Powered and electrical functions. ................ 25
5.3.1 Batteries and mains................................ 25
5.3.1.1 Battery charging introduction........ 25
5.3.1.2 Battery charging ........................... 26
5.3.1.3 Battery changing .......................... 26
5.3.1.4 Standby batteries ......................... 26
5.3.2 Powered motions ................................... 27
5.3.2.1 General ........................................ 27
5.3.2.2 Tabletop motions.......................... 28
5.3.3 Using the handset .................................. 28
5.3.3.1 General ........................................ 28
5.3.3.2 Handset button functions.............. 29
5.3.4 Using the standby control panel ............. 31
5.3.5 Fuse replacement .................................. 31
6.0 PATIENT POSITIONING ..................... 32
6.1 General ..................................................... 32
6.2 Treatment of the obese patient .................... 32
6.3 Radiographic procedures ............................ 32
6.4 Table positions and safe loading ................. 32
7.0 ACCESSORIES ...................................42
8.0 AFTER USE, CLEANING & CARE ...... 44
8.1 After use procedures ................................... 44
8.2 Cleaning ..................................................... 44
8.2.1 Operation table and accessories ............ 44
8.2.2 Mattresses and pads .............................. 44
8.3 Disinfection .................................................. 45
8.3.1 Disinfection procedure............................ 45
8.3.2 Table, accessories mattresses and pads 45
8.4 Care ..................................................... 45
8.5 Storing the operation table (long term) ........ 46
8.6 Maintenance ................................................ 46
8.6.1 General .................................................. 46
8.6.2 Fault diagnosis ....................................... 46
8.6.3 Environmental considerations ................ 46
8.6.4 Technical Lifetime .................................. 46
9.0 TECHNICAL DATA .............................. 50
9.1 Weights ..................................................... 50
9.2 Dimensions ................................................. 50
9.3 Movements.................................................. 50
9.4 Table loading ............................................... 50
9.5 Electrical ..................................................... 50
9.5.1 Antistatic requirements ........................... 50
9.5.2 Batteries ................................................. 50
9.5.3 Internal battery charger .......................... 50
9.5.4 Fuses ..................................................... 52
9.5.5 Duty cycle .............................................. 52
9.6 Classification and symbology ...................... 52
9.7 Use with other equipment ............................ 52
9.7.1 Electrosurgical equipment (h.f.) .............. 52
9.7.2 Defibrillation equipment .......................... 52
9.7.3 RF communications equipment .............. 52
9.8 Standards compliance ................................. 52
9.9 Environmental conditions ............................ 52
9.9.1 Operating environment ........................... 52
9.9.2 Transport & storage environment ........... 52
9.10 Alarms ..................................................... 52
9.10.1 Visual ................................................ 52
9.10.2 Audible .............................................. 53
9.11 Electromagnetic compatibility (EMC) ........... 53
9.11.1 Interference considerations ............... 53
9.11.2 Interference from other equipment .... 53
9.11.3 Interference with other equipment ..... 53
9.11.4 RF communications equipment ......... 53
9.11.5 Accessories....................................... 53
9.11.6 Installation ......................................... 53
9.11.7 EMC tables ....................................... 53
To Next Page
Loading...
