ESDEC FlatFix Fusion - Page 33

1.
31
Rev. 08.08.23 MANUAL FOR FLATFIX FUSION MOUNTING SYSTEM FOR FLAT ROOFS
SEGMENT PLAN
BALLAST POSITIONSNAME
P; XXkg P2; XXXkg
P3; XXXkg
DESCRIPTION
Standard (perimeter) ballast
position in front or single row.
2
nd
ballast container added due to
higher ballast requirements for posi-
tions in the rst or single row.
2
nd
and 3
rd
ballast container added due
to higher ballast requirements for posi-
tions in the rst or single row.
FIX / ALIGN
Position the ballast container using
the roof support adapters (spacers)
and screw it to the base proles.
Position the 2
nd
ballast container using
the roof support adapters (spacers)
and screw it to the base proles.
Position the 2
nd
ballast container using
the roof support adapters (spacers) and
screw it to the base proles.
Place the 3
rd
ballast container on the
high base elements, and align them
using the slots (holder) and lugs (base
elements).
WEIGHT DISTRIB..
Specied quantity of ballast in ballast
container 1.
Fill ballast container 1 to the maximum
level with ballast (do not stack) and
place the remainder of the specied
amount of ballast in ballast
container 2.
Fill ballast container 1 to the maximum
level with ballast (do not stack) and
place the remainder of the specied
amount of ballast in ballast container
2 and 3.
Single setup - 2/2
1.
2.
1.
2.
3.
NOTE!
Always completely ll
ballast container 1 rst,
followed by ballast
container 2, and then
ballast container 3.
Do not distribute the
amount of ballast
between the containers
themselves.