25
Etac / Cross 5 / www.etac.com
25
Foot supports
Adjust the height until you are sure that your feet are
supported and your thighs are resting on the cushion.
For outdoor use the foot supports should be raised 4-5
cm above the ground.
Adjusting the angle
Adjust the foot support angle, so the ankles are at 90°.
Adjusting the height
Loosen the knob and pull out the screw. Set the height.
Assemble the screw and knob and tighten firmly.
Arm support (adjusting)
• Loosen the screw on the inside of the arm support
plate.
• Set the required height and tighten the screw.
• The high position of the arm supports, supports and
relieves pressure on the back better than a lower
position.
5 mm
3 mm
Settings seat comfort
User manual
Calf/heel strap
• Adjust the length so that your insteps rest on the foot
supports.
Changing the depth of the foot supports
Adjust the depth of the foot supports by switching the
right and left foot support. Do not forget to adjust the
angle.
To Next Page
Loading...
