Etac Cross 5 - Adjusting Seat Depth Using Lumbar Angle (Two Eccentric Shafts)

36
Etac / Cross 5 / www.etac.com
1 2
1
1
5
5
5 mm
Cross 5 Cross 5 XL
An extended seat depth is achieved by opening the
back support angle (hip) and then the lumbar angle.
1. Adjust the back support angle (see also illustration
1-3 on page 32).
2. Adjust the lumbar angle to the required back sup-
port angle using the eccentric shafts as in point 4-5
on page 34.
3. If necessary fit seat extender (accessory)..
Tipping risk! Always check the anti-tip function after
adjustments!
6. Settings back support 3A
Adjusting seat depth using lumbar angle (two eccentric shafts)