ES4455.2 Load Carrier Board - User’s Guide 15
ETAS Introduction
1.3 Identifications on the Product
The Following Symbols are Used for Product Labeling:
Please observe the information in the chapter "Technical Data and Standards"
on page 47.
1.3.1 CE Mark
With the CE marking attached to the product or its packaging, ETAS confirms
that the product corresponds to the product-specific, applicable European Direc-
tives. The CE Declaration of Conformity for the product is available upon request.
1.3.2 KC Mark
With the KC mark attached to the product and its packaging, ETAS confirms that
the product has been registered in accordance with the product-specific KCC
guidelines of the Republic of Korea.
Symbol Description
The User's Guide must be read prior to the startup of the
product
Marking for CE conformity
(see "CE Mark" on page 15)
Marking for KCC conformity
(see "KC Mark" on page 15)
Only for ES4452.1 and ES4457.1
Marking for China RoHS, see chapter
(see "RoHS Conformity" on page 16)
Marking for conformity with WEEE directive
(see "Product Return and Recycling" on page 16)
Identification in accordance with ISO 7010:2011, P007: "No
access for persons with pacemakers and implanted defibrilla-
tors."
"Operational malfunction or damage to pacemakers and
implanted defibrillators".
To Next Page
