ES4455.2 Load Carrier Board - User’s Guide18
Introduction ETAS
1.6 About this Manual
This manual consists of the following chapters:
• "Introduction" on page 5
This chapter.
• "Design of an Injector Simulation Environment" on page 21
This chapter describes how the ES4455.2 Load Carrier Board and its vari-
ants ES4450.3, ES4451.4, ES4452.1, ES4453.1, ES4457.1 and
ES4458.1mounted with load modules can be integrated in a LABCAR HiL
system.
• "Properties and Functions" on page 21
This chapter features a description of the properties and functions of the
components of the ES4455.2 Load Carrier Board and its variants
ES4450.3, ES4451.4, ES4452.1, ES4453.1, ES4457.1 and ES4458.1
mounted with load modules.
• "Connections and Connectors" on page 37
This chapter describes the connections of the ES4455.2 Load Carrier
Board and its variants ES4450.3, ES4451.4, ES4452.1, ES4453.1,
ES4457.1 and ES4458.1 that are mounted with load modules.
• "Technical Data and Standards" on page 47
This chapter contains information about the technical data and standards
of the products.
• "Ordering Data and Scope of Delivery" on page 49
1.6.1 Working with this Manual
Presentation of Information
All activities to be performed by the user are presented in a "Use Case" format.
That is, the goal to be accomplished is briefly defined in the heading, and the
respective steps required for reaching this goal are then presented in a list. The
presentation looks as follows:
Target definition
any advance information...
1. Step 1
Any explanation for step 1...
2. Step 2
Any explanation for step 2...
Any concluding comments...
Specific example:
Creating a new file
Before creating a new file, no other file may be open.
1. Select File → New.
The "Create File" dialog box appears.
To Next Page
