ETC Source 4WRD - Connect cables

10 Source 4WRD Installation and User Manual
Connect cables
You can control the fixture using AC power or DMX. Configure the
fixture to use the appropriate control method on the user interface.
See Configure the fixture on page13 .
WARNING: Do not use or store the Source 4WRD fixture below 5°C
(41°F). When the fixture has been stored or transported in cold
temperatures, allow it to warm to room temperature for a minimum
of 1 hour before applying power. Applying power to a cold fixture will
cause damage to the fixture and void ETC warranty.
Note: For optimum performance, make sure that your dimmer is out
of regulated mode. See Line-dimming on the facing page for
recommended dimmer settings.
Note: Connecting both power and data from a SmartBar 1 to a
Source 4WRD fixture may cause flickering.
1. If you are using DMX control: Connect one RJ45 data cable for
data-in and one for data-thru, as needed. Use the strain relief
at the bottom of the fixture to support the data cables.
•
To order an RJ45-to-female XLR adapter, use ETC part
number W6538.
•
To order an RJ45-to-male XLR adapter, use ETC part
number W6539.
2. If you are using DMXcontrol and this is the last fixture in the
line, terminate the fixture with a 120Ohm resistor. Please
contact your ETC customer service representative to purchase
ETC part number N4086. See Help from ETC Technical Services
on page2 .
3. Connect the fixture to the power source.