ETC Source 4WRD - Retrofit the fixture; Wire the power connector (if needed)

6 Source 4WRD Installation and User Manual
Retrofit the fixture
WARNING: RISK OF FIRE OR ELECTRIC SHOCK! Installing the
Source 4WRDLED retrofit kit requires knowledge of luminaire
electrical systems. If you are not qualified, do not attempt
installation. Contact a qualified electrician.
AVERTISSEMENT : RISQUE D'INCENDIE OU DE DÉCHARGE
ÉLECTRIQUE! Installer le nécessaire de conversion Source 4WRDLED
nécessite une connaissance des systèmes électriques de projecteurs.
Si vous n’êtes pas qualifié, ne tentez pas l’installation. Faire appel à
un électricien qualifié.
Note: THE RETROFIT KIT IS ACCEPTABLE AS A COMPONENT OF A
LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL
BE DETERMINED BY AUTHORITIES HAVING JURISDICTION.
Source 4WRD
LED Retrofit Kit
LEDs
RJ45 data in
and data thru
User interface and
navigation buttons
Wire the power connector(if needed)
If you ordered a Source 4WRD retrofit without a power connector,
wire the connector in accordance with all national and local electrical
codes:
•
Brown = Line
•
Blue = Neutral
•
Green/Yellow = Ground