ETC Source 4WRD - Default Chapter; Table of Contents

Table of Contents
Source 4WRD Installation and User Manual i
Introduction 1
Help from ETC Technical Services 2
Safety 3
Retrofit the fixture 6
Wire the power connector(if needed) 6
Remove incandescent lamp housing 7
Install the Source 4WRD retrofit 7
Install the fixture 9
Attach C-clamp and safety cable 9
Connect cables 10
Configure the fixture 13
RDMvalues 13
Focus the fixture 14
Set the Z-adjustment 14
Adjust the yoke position 14
Shape the beam 15