ETC Source 4WRD - Clean and maintain the fixture

Source 4WRD Installation and User Manual 17
Clean and maintain the fixture
Clean the fixture
CAUTION: Do not touch or clean LED optic domes with anything
other than oil-free canned air.
Fan and
fin stack
•
Use oil-free canned air to clean the
LED domes prior to installation and
prior to storage.
•
Use oil-free canned air to clean the
fan and fin stack as part of regular
fixture maintenance.
Store the retrofit
Store with
LED dome up
•
When not installed on a fixture, store the
Source 4WRDLED in its original packaging or
in a dust-resistant plastic bag.
•
Store the Source 4WRDLED at temperatures
of 5°C (41°F) or higher.
•
If you must store the Source 4WRDLED
below 5°C (41°F), make sure it is in an
upright position as shown to the right. Allow
it to warm to room temperature for a
minimum of one hour before applying
power.
Note: After shipping or storing the Source 4WRDLED below 5°C
(41°F), visually inspect the unit to ensure the low temperatures have
not caused cracking of the LED array.