DETERGENT DOSING SYSTEM GREEN INDICATOR LIGHT
When the indicator light is on, this indicates the detergent dosing system is on.
BRUSH BUTTON
Press this button to enable the brush function; a green led light will come on and the
brush plate will descend. The brushes will start rotating when the forward pedal is
pressed. When the forwards pedal is released, the brushes will rotate for other 3
seconds before stopping. In case of prolonged halt, after 1 min the brush plate will
automatically rise.
When the machine is in motion with lowered brushes, by pressing the brush button
the brushes will stop rotating and the brush plate will rise.
The electrovalve and the solution pump are also connected to the brush function and
allow the user to automatically open or shut the flow of the solution while the brush
is rotating.
This function cannot be activated if there is not solution in the tank. In this case by
pressing the button, the five led lights on the solution metering unit will start
flashing and the brush function will not be enabled. When this occurs, make sure to
fill the tank.
This function will be automatically deactivated in case there is no solution in the
tank. When this occurs, the five led lights on the solution metering pump will start
flashing and the brushes function will be deactivated.
GREEN ON/OFF BUTTON
This button enables the operator to use all the functions of the machine. Press the
button once to lower the brush plate and the squeegee, the led lights on this button
and on the brush and suction fan buttons will come on. Push the drive pedal to start
rotating the brushes and the solution metering pump.
The vacuum motor will also turn on. The quantity of water used will equal to the
quantity stored after the last use.
Press this button again to stop the operation of the brushes and the brush plate will
lift from the floor.
The squeegee will also lift from the floor with a preset delay to allow the operator to
dry the entire floor.
If this button is pressed when the tank is empty, the five led lights on the solution
metering unit will start flashing and the brush function will not be enabled, but only
the squeegee. When this occurs, make sure to fill the tank.
To Next Page
Loading...
