rotating.
This function can not be activated if there is not solution in the tank. In this case by
pressing the button, the five led lights on the solution metering unit will start flashing
and the brush function will not be enabled. When this occurs, make sure to fill the tank.
This function will be automatically desactivated in case there is no solution in the tank.
When this occurs, the five led lights on the solution metering pump will start flashing
and the brushes function will be desactivated.
HOUR METER BUTTON
Hold down this button to display the operating hours of the machine.
CHARGE BATTERY LEVEL INDICATOR AND DISPLAY
The charge level of the battery is displayed when the machine is switched on (100 – 90
– etc). When the battery charge level reaches 20, the number on the display starts
blinking and the brush operation is disabled raising the plate, since a protection
device is triggered to prevent the battery from getting damaged, however the
suction and forward functions remain active.
At this point, the brush plate shall be raised and the floor shall be dried quickly.
Upon reaching level 10, the number on the display shall start blinking and the suction
function will also be disabled, the forward function will be the only active function. Lift
the squeegee, go to the tank drainage area and charge the batteries.
When 4 blinking dashes (----) appear on the display, the forward function will also be
disabled as the battery reaches a minimum discharging threshold. Therefore, the
machine must be pushed over to the tank drainage area and then pushed over to the
battery charging area.
ECO-SYSTEM OPERATION BUTTON
Press this button to enable the ECO-SYSTEM.
The green light is on when the system is operating.
If the button is pressed and the led light does not come on, it means that the solution
level on the recovery tank is too low and therefore, the function cannot be enabled.
Continue to wash in “normal” mode until reaching the minimum level. However, it is
advisable to have enough solution in the recovery tank for better performance in the
ECO-SYSTEM mode.
If the level on the recovery tank goes below the minimum level required for the ECO-
SYSTEM function, all five led lights on the water metering unit will start flashing and
the brushes will stop operating.
SUCTION FAN BUTTON
If the suction fan is switched off, this button can be used to turn it on, the squeegee lowers
and a green light indicator will come on.
If the suction fan is switched on, the light will start flashing, when this button is pressed,
but the suction function will remain active for a fixed period of time and once lapsed the
squeegee will lift and the suction function will come off.
The warning light will start flashing even when the machine is in reverse drive to
indicate that the squeegee is being raised from the floor.
The suction function may turn off automatically when the solution on the recovery tank
is too full. The machine is equipped with a float that switches off the function when the
tank reaches its maximum level. In case of prolonged idle time, the suction fan will
switch off automatically after 1 minute regardless of whether the squeegee does not lift
automatically from the floor for safety reasons, but must be lifted by pressing the button
WATER ADJUSTMENT BUTTONS
Use the buttons + or – to set the maximum quantity of water to use for the operation. Press
the + button to increase the quantity of water; the 5 green led lights on the panel come on
progressively one at a time.
Each led light is associated with a maximum pre-set quantity of water.
Press the - button to decrease the quantity of water; the 5 led lights will go out progressively
one at a time. The water is shut off when all the led lights are off.
The machine keeps memory of the preset quantity of water even when switched off. If the 5
led lights start flashing at the same time, this means that there is no solution into the tank.
To Next Page
Loading...
