Eventide ARGUS 5000 - Page 131

AMEND PAGE 7: Airport Runway Characteristics
AIRPORT SELECTION
RUNWAY LENGTH
•^2000
RUNV/AY SURFACE
Y ASPH/CONC
Y TURF
N DIRT
N GRAVEL
N TREATED
N ICE
N SNOW
N WATER
CONTINUED...
PAGE
LINE
CHG
RTN
PROCEED TO NEXT PAGE
you don't want to display
runways is ASPH/CONC,
This AMEND page allows you to deselect airports based
upon runway characteristics. The first item cycles
through runway lengths, starting at 2000, the shortest
available in the database, and going in 200 foot steps to
8000 feet. If you select, for example, 3,000, no airport
will be shown on the map unless it has at least one
runway whose length is greater than or equal to 3,000
feet.
The remaining lines on this page refer to runway surface
characteristics. Selecting Y next to ASPH/CONC means
that you want to display airports whose runways are
asphalt or concrete. Selecting N next to DIRT means
airports with dirt runways. (Unless, of course, one of the
to use the same example.)
Select Y for all surface types that you are willing to land on.
AMEND PAGE 8: Airport Type
This AMEND page allows you to select or reject airport
types based on ownership and on fuel availability.
Placing Y in front of CIV PUBLIC means you want to
show civilian public airports. Placing N in front of MIL
PRIVATE means that you don't want to show military
private airports, i.e., those at which the public isn't
welcome.
If you're in IMC, you can reject airports without
instrument approaches as listed by placing N in front of
"APTS. W/O ILS/LOC/LDA APPROACHES."
AIRPORT SELECTION
FACILITY ACCESS
Y CIV PUBLIC
*N CIV PRIVATE
Y MIL PUBLIC
Y MIL PRIVATE
Y APTS. W/0
ILS/LOC/LDA
APPROACHES
Y UNLIGHTED
FUEL TYPE REQ.
NONE
PAGE
LINE
CHG
RTN
AIRPORT SELECTION END
The FUEL SELECTION item permits you to reject
airports with no JET A fuel, for instance, by selecting JET A on the line. NONE
means that you will accept the airport regardless of fuel availability. If you need
July 1999 Argus 5000/7000 Ver. 5.xx Reference Manual Part#141003 125