Eventide ARGUS 5000 - Page 148

The following escape sequences are non-standard VT-100 ANSI codes
<ESO[ 1 Om Set to "small" font.
<ESC>[ llm Set to "medium" font.
<ESO[12m Set to "large" font.
<ESO[13m Set to "monospace" font.
<ESO[14m Set to "giant" font.
<ESO[BBh Set the CRT brightness to "BB" percent of maximum brightness.
<ESC>[TTi Set the repeat rate for held buttons to TT * 20 milliseconds.
Argus screen information
The Argus has four "layers" of screens that can be drawn to. Only the front layer is
visible to the user, but all four layers are identical as far as drawing is concerned. This
feature can be used to advantage under several circumstances:
1: If it takes a long period of time to accumulate information for display, and you
would like to leave the previous information available in the interim.
2: You can draw a special screen to be used for an urgent notification that must
be available on a moments notice. Since displaying an already-drawn screen
is much faster than drawing one from scratch, the three undisplayed layers can
be held in reserve and displayed almost instantly when necessary.
3: A higher numbered screen can contain elaborate formatting data (many boxes,
lines, etc.) That screen can be copied forward after which only alphanumeric
data need be added. Then, the screen with the data and formatting can be
copied forward to the display screen. The screen with the formatting, if it has
not been overwritten, can be reused with a different set of data.
July 1999 Argus 5000/7000 Ver. 5.xx Reference Manual Part#141003 143