Eventide ARGUS 5000 - Page 183

Argus outside the aircraft with a bench power supply. If the problem goes away, it's
probably due to defective remote switch wiring.
PROBLEM: I am having trouble with the REMOTE switches. They don't seem
to do anything.
First, check the suggestions outlined in the answer above. Try manually shorting the
contacts at the connector. In this case, it is more likely that there is an open circuit
than that there is a short.
PROBLEM: The map works fine, but an airport/VOR/NDB seems to be
missing.
In the case of an airport, confirm that it has a runway of at least 2000 feet. This is the
minimum in the database. Confirm that all the AMEND categories related to the item
have been selected to Y. Remember that the first AMEND page acts as a "master
switch" for entire categories of facilities. Review operation of the AMEND mode.
PROBLEM: I've done that. It's still missing.
Check the expiration date of the database shown when the Argus is turned on. If the
facility opened or was activated after this date, it may appear in more recent databases.
If you're sure that it should be there and isn't, it's possible that for some reason it was
omitted from our data tapes. Please write to us with information on the erratum; be
sure to state facility type, identifier, latitude, longitude, and any other information that
will help us find (or not find) it. We will notify the appropriate agency.
PROBLEM: The frequency (name, runway data) of a facility is incorrect.
See answer to previous question. This type of information changes more frequently
than does the existence of a facility. With time, the cumulative effect of these changes
might cause you to consider getting your database updated. See Appendix 1 for more
information on the procedures.
^ PROBLEM: I have a question or difficulty not discussed here.
Before calling for assistance, please see the Eventide world wide web site,
July 1999 Argus 5000/7000 Ver. 5.xx Reference Manual Part#141003 179