DESCRIPTION OF THE MAIN PARTS
1.
HYDROS TATICTRANS MISSION
This
is
an assembly of components enabling the movement of the machine. Theassembly mainly consists
of:
-variable-flow hydrostatic pump connected to the combustion engine via an elastic coupling.
-
a hydraulic unit fitted on the differential pinion of the front axle.
-
two
radial piston hydrostatic motors,
one on each
wheel, for the rear axle.
A
solenoid valve which ensures differential
blocking,
and can be
selected using a button
on
the lower part of the joystickhandle (only
on
4WD
versions).
-
a hydraulic fluid filter in the tank suction line.
-
a cooler for the hydraulic oil circuit
2.
FRONT AXLE
The front axle transmits the movement from the hydraulic unit to the wheels
3.TYRES
The machine
is
equipped with tyres with the appropriate dimensions for the maximum load accept-
ed on the
forklift.
Should tyres be changed, systematically replace them with tyres with the same dimensions and
load carrying
properties.
4.
THE PARKING BRAKE is a negative system and actuates the disk assembly of the servicebrake
(hydraulic actuation).
This brake is activated using a switch located to the left of the instrument panel, facing theoperator.
5.
TOWING HOOK (IF FITTE D)
The machine may be
fitted
with a rear connection and
pull
authorized
trailers.
·Check if your machine is equipped with optional accessories
To Next Page
Loading...