PRIOR PREPARATION WHEN STARTING UP THE FORKLIFT
Place the machine in its working position and check that the machine is on the level.Before
starting operations:
-Check that maintenance operations are carried out carefully, and that the specified time intervals are
applied (see
section 4 on “MAINTENANCE”).
-
Check that enough
fuel exists in
view of autonomy, to avoid the
risk
of the engine stopping suddenly
during a
critical
manoeuvre. Always stop the engine before
refuelling
and never smoke during the
process. Do not mix
gasoline or alcohol with the fuel.
-
Carefully clean the instruments, plates and labels, lights, rear view mirrors and wing mirrors (if fitted).
-
Check that
all
safety devices fitted on the machine operate correctly and in the working area.
-
It is prohibited to
make
tideover repairs simply to be able to start work
-
Should any difficulties or problems of any type arise, immediately notify your superior.
Do not start any job without complying with safety requirements.
If
you notice any anomaly while using
the forklift,
inform the maintenance service immediately.
Before starting work with the forklift, clean up any possible oil or fuel which may have leaked, clean and
remove
any
grease from your hands and the soles of your shoes and
remember
to check the followingitems:
-
Tyre pressure and tread condition.
-
Check brake functioning.
-
Check for any leaks in the hydraulics, fuel and cooling system, etc.
-
Check that
all
protectors, covers and safety end stops props are correctly positioned and properlyattached.
-
Check that there are no cracks or other structural defects visible to the naked eye.
-
Check the correct operation of all controls.
-
Check levels of fluids and lubricants:
·fuel.
·inching circuit fluid. hydraulic fluid.
·coolant.
·engine oil
-Check the seatbelts and their mountings are in good condition and properly fixed. Carefully inspect
the condition of
this device paying special attention to:
To Next Page
Loading...
