·cuts or loose threads on the belt.
·wear or
damage
to fittings, including anchor points.
·incorrect functioning of the seat belt buckle or retracting roller.
·loose seams or stitching.
-Check that all covers, locks and other safety elements are correctly positioned. The removal of safety
devices such as
the engine cover
is
prohibited with the exception of for maintenance purposes. Should
it
be necessary to remove
these devices, stop the engine, and pay close attention during the operation.
Replace
the devices before starting the engine and operating the machine.
-Check the correct functioning of alarms and signalling devices (for example: acoustic warning,obstruction indicator
for the air admission filter, etc.)
-Check that all the information and safety plates on the forklift are clean and in good condition.
Danger warning
signals must not be removed, covered or unreadable.
-
Check that the lighting and signalling system is clean and working properly (if fitted).
-
Check the electric battery connections and the level of electrolyte.
-
Adjust the seat position so that you are comfortable and can easily reach the controls.
-
Do
not start the forklift or operate the controls unless you are in the operator’s seat.
-
To ensure your safety should the machine
roll
over, do not forget to correctly adjust and fasten the
seat
belt.
To Next Page
Loading...
