Proper fan
belt
tension
is
when a deflection of between 7 and 9
mm
(0,28 to
0,35
in.),
when the
belt is
under a load of 10 kgf (22,1
lbs) in
the middle of the span.
Stop the engine and remove the ignition key.
Apply moderate thumb pressure to the belt between the pulleys.
If the tension is incorrect, loosen the alternator mounting bolts and, using a
lever placed between the alternator and the engine block, pull
the alternator out
until belt falls within acceptable limits.
Replace the belt
if
damaged.
BATTERY
-
Check
the level of electrolyte in the battery after every
250
hours of operation; top
up
with distilled water if necessary.
-
Ensure that the
fluid
covers the elements by 5-6
mm
(2-2’3
in)
and that
all cells
have the necessary
level.
-
Check
that all cables are firmly secured to the battery terminals. Always use a fixed
clamp
to tighten connectors
rather than alligator clips.
-
Protect the terminals by covering with pure vaseline.
-
If the machine is liable to not
be
used for a lengthy period, it is
recommended
to dismantle the battery
and
place in a
dry location.
-
The
electrolyte in the battery contains sulphuric acid which
may
cause burns
if it
comes
into contact with
the skin or eyes.
Wear
protective goggles
and
gloves
and move
the batterycarefull
to avoid electrolyte
leakage. Keep all metal objects (watches, rings, chains) at a distance from the
battery, as they
may
cause a short
circuit
and
burns.
-
Before connecting or disconnecting the battery, turn off all of the switches in the cab.
-
To disconnect the battery, remove the negative terminal
(-)
from the ground.
-
Connect the positive terminal (+) first.
-
Recharge the battery at a distance from the machine in a well ventilated area.
-
Never approach the battery with objects which may produce sparks, bare flames or with ciga-
rettes.
-
Avoid placing metal objects on the battery. This could cause dangerous short circuits, especial-
ly during
recharging.
-
Given that electrolyte is highly corrosive, avoid any contact with the forklift chassis or with elec-
tric
or electronic
components. Should contact occur, contact your authorized
ERT1500
dealer.
To Next Page
Loading...
