ENGINE CONTROLS
A:Neither
circuit is
supplied. You
may
remove the key and the engine
is
stopped.
B:Circuits are supplied, ready to start the engine. Engine
oil
pressure, battery charge and pre-heating lamps
all light
up.
If
the pre-heating lamp
is lit, this
indicates that the pre-heating resistances are
operational and heating the combustion
chamber to a temperature which
will
enable the
firing
of the
vaporised diesel fuel.Wait
until this light
goes out before
starting the engine.
C:Start the engine. When the key is released, it will automatically return to its initial position.
BRAKE
Press the pedal (1
)
to bring the machine gradually to a stop. You
may
accelerate the engine to
move
the
horizontal
arm more
rapidly. Press the pedal to the floor to gradually activate the service
brake.Slowly release the
pedal. The machine will start to move.
To Next Page
Loading...
