press the throttle pedal a
1/4
of the
way and
turn the
key
to position (C) until the engine starts.
Do
not hold this
position for
more
than
15
seconds. If the engine
does
not start repeat the previous oper- ations. Wait for
30 seconds
between each
try.
A
device is fitted enabling the seat to
be moved
forward or
back
to adjust the distance
from
the pedals.
To
adjust
the seat, turn the lever (1 )
and push
the seat in the desired direction.
Once
in posi-tion, release the lever
and
ensure
that the seat
During extended periods of
inactivity,
also remember that periodic maintenance must be carried out and
close attention must be paid to
all liquids
and elements which may age.
In all events, before starting the forklift, carry out a complete overhaul checking all mechanical,hydraulic and electric
parts.
CLEANING AND WASHING THE MACHINE
CLE
ANING INSTRUCTIONS
Comply with the following instructions to clean the machine in a satisfactory manner:
-
Clean parts of oil or grease using solvents or volatile mineral alcohol.
-
Remove
all
protective
substances
(rust
inhibitor,
grease,
wax
,
etc.)
-
If signs of rust appear
on
metal parts of the forklift, clean using an
emery
board
and
coverwith an
appropriate protection substance (rust
inhibitor, varnish, oil, etc.).
-
When the
forklift is
used
in salt
water areas (beach areas,
etc.),
rinse with clean water to preservethe
forklift
and
its
components.
-
When
the
forklift is
operated
in
muddy
conditions, rinsing the
dumper
is
recommended
to preservethe
forklift
and
its
components.
Lubrication of metallic parts
is
highly recommended.
This must be performed at the end of each operation day.
WASHING THE MACHINE
External was hing
During the washing process, care must be taken to avoid aiming the pressurised water
jet
at the
air intake (air filter),
battery, instrument panel, alternator and other electrical equipment since this can
damage the components.
INTERIOR WASHING
Wash the inside of the machine using, water, a bucket and a sponge. Do not use low-pressure water
To Next Page
Loading...