START-UP
For safety reasons
when
starting the
forklift,
the operator must be seated with the seat belt fastened, the parking
brake must be applied, and the operator must check that the joystick and the
FNR switch are in the neutral position.
Insert the key into the starter switch and turn it to position (B) until the pre-heat indicator turns off, press the throttle
pedal a 1/4 of the way and turn the key to position (C) until the engine starts.
Do
not hold this position for
more
than
15
seconds.
If
the engine does not start repeat the previousoperations. Wait for
30
seconds between each
try.
If
the indicators / warning lights do not go out when the engine starts to run, stop the engine
immediately and
identify the causes of the incorrect operation.
It is not possible to start the engine if the FNR switch is not in a neutral position.
After
starting
the
engine,
the
engine
will
continue
to
run
if
t
he
operator
leaves
the
driver
’
s
cab.
Do
not
go
far
from
the
driver
’
s
cab
without
stopping
the
engine, lowering
the
arm
to
the ground,
and
applying the
parking brake.
To Next Page
Loading...
