EVERUN ERT1500 - HYDRAULIC FLUID AND FUEL TANK; SUPPLY CIRCUIT

50
The right side cover may be removed to simplify mainte- nance
operations. An inspection gate also exists in each cab floor
panel
To access components located behind the right side cover:
-Loosen the 4 attachmentscrews (A)located in the upperflap
and remove the Cover
HYDRAULIC FLUID AND FUEL TANK
The fuel and hydraulic fluid tanks are located on the leftside of the
forklift.
- Fuel tank (C) .
- Hydraulic fluid tank (D).
SUPPLY CIRCUIT
WARNING
Never mix oil with the fuel. The forklift has a 4-stroke engine. Oil must be added in the engineonly.
Draining the fuel tank. Tank
drainage plug
Fuel can be drained via the plug situated on the lower part of the tank.
- Clean the area around the fuel drainage cap plug.
- Place a container underneath the fuel drain plug.
- Unscrew the plug.
- Change the seal in the fuel drain plug. Clean the tank seal area and the oil
drainage plug and replace the plug.
Ensure that there are no leaks from the fuel drain plug.
WARNING
Clean any fuel spillage.
C
B
C
D