5.4 Tools Required
Preparation before Installation
26
Type
Tool equipment
Name
Image
Name
Image
Safety
gloves
Safety
shoes
Individual
Protection
Tool
Safety
goggles
Anti-dust
mask
Machine Installation Tools
Drill
Allen key
Crosshead
screwdriver
Utility knife
Crimping tool
for RJ45
MC4
crimping tool
Multimeter
Marker
tape
Measuring
Mallet
Wire stripper
Crimping tool
Spirit level
Diagonal
pliers
Electrical
hex wrench
Hot-air
blower
Flat-head
screwdriver
27
6. Plan the Installation Site
Choose a wall capable of supporting the full weight of inverter, battery and EV-SB. If
floor-mounting inverter and battery, choose a level surface adjacent to the below
wall.
Choose a propriate location
Choose cable entry of inverter
A conduit fitting or cable gland must be used when wiring connection.
For the wiring connection of inverter, the cable is routed from the right side of
inverter. Totally four 1 inch openings are available for connecting.
Wood studs spaced at 12, 16, 20, 24, 28 and 32 inch
Steel material of sufficient thickness
Solid concrete or masonry
C
DA
B
E
G
Item
A
B
C
D
E
F
G
BAT+
AC conduit plug
Inverter communication connection
PV conduit plugs
PV conduit plugs
BAT-
Description
Battery communication connection
F
Plan the Installation Site
To Next Page
Loading...