Mechanical Installation
7.4 Wall-mounting
Step 1: Mount the battery
a) Take out of the accessories from a separate accessory box. Fix the base
support on the transverse plate with M5 countersunk head screw.
Studs spaced at 12, 20 and 24 inch: secure the transverse plate and base support
using screws (2×M5*8 countersunk head screw), and tighten them. See figure
below.
Studs spaced at 16, 28 and 32 inch: secure the transverse plate and base support
using screws (2×M5*8 countersunk head screw), and tighten them (Tighten torque:
2.2-2.5 N·m). See figure below.
2
0 in/
508
.
0
m
m
24
in
/
60
9
.
6
m
m
3
2 in/
8
1
2
.8
m
m
2
8 i
n
/
7
1
1
.
2
mm
M5
17.7 lbf.in /
2.0 N·m
M5
17.7 lbf.in /
2.0 N·m
59
58
Mechanical Installation
NOTE!
Drilling a hole in the wall is required before cutting a hole in the rear.
To guarantee easy installation of the conduit and sealing with the
chassis, the hole's size must be greater than the conduit's outside
diameter.
d) The top of the nut and contact surface of the threads must be cleaned after
locking the nut, as well as the contact surface between the nut and the box. TSE-382
waterproof adhesive or a similar performance glue.
NOTE!
Prohibit the flow of water inside the tubing water into the machine!
c) Lock nut, waterproof gasket(outside), conduit.
To Next Page
Loading...