EVERVOLT EVHB-I7 - About this Manual; Scope of Validity; Target Group; Symbols Used

About this Manual
1
1.1 Scope of Validity
1 About this Manual
7.4 WALL-MOUNTING..........................................................................................59
8 WIRING CONNECTION ON THE INVERTER........................................................62
8.1 OVERVIEW OF ALL ELECTRICAL WIRING METHODS..................................62
8.2 POWER CONNECTION...................................................................................64
8.2.1 PV CONNECTION..................................................................................66
8.2.2 GRID CONNECTION..............................................................................68
8.2.3 BATTERY CONNECTION.......................................................................70
8.3 GROUND CONNECTION...............................................................................72
8.4 COMMUNICATION CONNECTION................................................................74
8.4.1 MAKE CONNECTION TO ANOTHER INVERTER/SB............................74
8.4.2 EPO CONNECTION...............................................................................80
8.4.3 RGM (METER X) CONNECTION (OPTIONAL).......................................80
8.4.4 EXTERNAL ELECTRICITY METER CONNECTION (OPTIONAL)...........80
8.4.5 RSD TRANSMITTER CONNECTION.....................................................80
8.4.7 MONITORING CONNECTION (OPTIONAL)..........................................82
9 WIRING CONNECTION ON THE EV-SB.............................................................83
9.1 INSTALL A MAIN BREAKER (PURCHASED SEPARATELY)......................... 83
9.2 INVERTER, GENERATOR, LOAD AND GRID CONNECTION....................... 85
9.3 MAKE COMMUNICATION CONNECTION.....................................................92
10 CLOSE WIRING COVER AND TURN ON THE SYSTEM....................................98
10.1 CHECK BEFORE TURN ON THE SYSTEM..................................................98
10.2 TURN ON THE SYSTEM..............................................................................98
10.3 SHUT DOWN THE SYSTEM.........................................................................99
11 INDICATOR LIGHT AND BUTTON...................................................................100
12 TROUBLESHOOTING.......................................................................................105
13 MAINTENANCE...............................................................................................117
14 COMMISSION THE SYSTEM............................................................................120
APPENDIX A: WIRING AND BREAKER REQUIREMENT.....................................123
APPENDIX B: EPO CONNECTION STEPS...........................................................128
APPENDIX C: METER Y CONNECTION DIAGRAM..............................................129
APPENDIX D: SYSTEM WIRING DIAGRAM.........................................................130
This manual is an integral part of the EVERVOLT Home Battery System including
EVERVOLT Hybrid Inverter, battery and SmartBox. It describes the assembly,
installation, commissioning and maintenance. Please read it carefully before
operating. Store this manual where it will be accessible at all times.
WARNING!
Save these instructions. This manual contains important
instructions for EVERVOLT Hybrid Inverter that shall be followed
during installation of the system.
1.2 Target Group
This manual is for qualified electricians. The tasks described in this manual
should only be performed by qualified electricians.
1.3 Symbols Used
WARNING!
“Warning” indicates a hazardous situation which, if not avoided, could
result in serious injury or death.
DANGER!
“Danger” indicates a hazardous situation which, if not avoided, will
result in serious injury or death.
CAUTION!
“Caution” indicates a hazardous situation which, if not avoided, could
result in minor to moderate injury.
NOTE!
“Note” provides tips for the optimal operation of our product.
The following types of safety instructions and general information appearing in
this document are described below:
8.4.6 PARALLEL CONNECTION ...................................................................81